433MHz Universal rf Remote Control Switch DC12V 10Amp 2CH rf Relay Receiver and Key fobs for Universal Garage and gate Control
RF Output of Good Stability
Wide Availability
Perfect Craft & Detail Control
NO : Normal open COM : Common NC : Normal closed
Excellent Detail Design
-
Working Voltage : DC 12V
-
Input vlotage : 1~250V
-
Output vlotage : 1~250V
-
Quiescent Current : <5MA
-
Max current : 10A
-
Max Load : 2200W
-
RF frequency : 433MHz
-
Working temperature : -30~+80
-
Receiving Sensitivity : >97dbm
-
Amount of storage remote controls : 25 pieces
-
Support encoding : 1527 Leaning code/2262 fixed code
-
RF Operating mode : ASK superheterodyne wireless reception
-
Receiving range : Open space is more than 50 meters
-
Remote operating mode : Momentary Mode /Toggle Mode /Latched Mode
Package include
Receiver module ( include Shell )
Remote Control (include battery )
Product Manual
Wiring Diagram 
Momentary Mode:
1. Press and hold one button, relay “1” will turn on;
2. Release the button, this relay “1” will turn off.
Toggle Mode:
1. Press button “A”, relay “1” will turn on;
2. Press button “A” again, this relay “1” will turn off.
Latched mode:
1. Press button “A”, relay “1” will turn on;
2. Press button “B”, relay “2” will turn on, at the same time relay “1” will turn off.
Delete the existing data about operating modes
Press the learning button (on the Receiver) 8 times. The existing data will be deleted succeed.
Note:
1. When you receive our products, it may set in one remote mode randomly, that because each product was tested before it can be arranged to shipment. So, please delete the existing data to first use.
2. After deleted the data, all the remote controls cannot work any more.
Set up(Momentary)
1. Press the learning button(on the Receiver) once. Wait for 3 seconds;
2. Press button “A” on the remote control. Wait for 3 seconds.
3. Press button “B” on the remote control. Wait for 3 seconds. Succeed.
Set up(Toggle)
1. Press the learning button(on the Receiver) twice. Wait for 3 seconds;
2. Press button “A” on the remote control. Wait for 3 seconds.
3. Press button “B” on the remote control. Wait for 3 seconds. Succeed.
Set up(Latched)
1. Press the learning button(on the Receiver) triple. Wait for 3 seconds;
2. Press button “A” on the remote control. Wait for 3 seconds.
3. Press button “B” on the remote control. Wait for 3 seconds. Succeed.
Note:
Delete the existing data before you want to change the operating mode of one remote control.
Recensioni
Ancora non ci sono recensioni.